|
|
| |
  |
Product description
Back to top |
S-Light SLR-250-IQ-Pyz optoelectronic receivers are optimized for
short distance high data rate optical communications.
The SLR-250-IQ-Pyz
complies with AEEC / ARINC 804 receiver specifications.
SLR-250-IQ-Pyz
modules integrate state-of-the art GaAs PIN photodiode chips and low
power consumption CMOS electronics. SLR-250-IQ-Pyz optical interface
consists of either a 50/125 or a 62.5/125 µm multimode optical
cable pigtail terminated by the end-user specified optical terminus
or connector.
SLR-250-IQ-Pyz
electrical interface consists of a QFN package |
| |
|
Applications |
Features
Back to top |
Severe environment interconnects
Sensors interconnects
Numerical video
transmission
Board-to-board
communications
Datacommunications
(LAN, SAN)
On-board communications
|
Up to 3.125 Gbps
Complies with
IEEE Std. 802.3z Gigabit Ethernet 1000 Base-Sx PMD and ARINC 804 requirements
Also suitable
for Fibre Channel and Infiniband requirements
Operation over
the industrial temperature range [-40;+90°C]
Temperature
excursions up to 125°C proved
Monitoring
of the optical power over the temperature range
Standard electrical
SMT interface
Small package
size (16x16x3mm)
Pigtailed optical
connectics
Low power consumption
(less than 165mW at 90°C)
|
| |
|
|
Principal Parameters
Back to top |
|
Notes:
1.
Power consumption when operating at full speed over the temperature
range. Maximum power consumption
occurs at 90°C.
2.
The module operates with decreased performances above 90°C. |
|
Notes:
1.
Measured at 20% / 80% levels. |
|
| |
|
|
Available Products
Back to top |
| Several versions of SLR-250-IQ-Pyz
receivers are currently available (c.f. table below). All use high
temperature grade optical cables. |
|
| |
|
|
Evaluation Board
Back to top |
| An evaluation board
(ref : EVB-SLM/01) is available for module testing. A module holding
tool (ref HT-DLM-v1.0) permits module testing without soldering up
to 3.125Gbps. |
|
